Do not call SplitBlockPredecessors on a loop preheader when one of the
predecessors is an indirectbr. Otherwise, you will hit this assert:
!isa<IndirectBrInst>(Preds[i]->getTerminator()) && "Cannot split an edge from an IndirectBrInst"
llvm-svn: 153134
alignment. If that's the case, then we want to make sure that we don't increase
the alignment of the store instruction. Because if we increase it to be "more
aligned" than the pointer, code-gen may use instructions which require a greater
alignment than the pointer guarantees.
<rdar://problem/11043589>
llvm-svn: 152907
It was added in 2007 as the first cut at supporting no-inline
attributes, but we didn't have function attributes of any form at the
time. However, it was added without any mention in the LangRef or other
documentation.
Later on, in 2008, Devang added function notes for 'inline=never' and
then turned them into proper function attributes. From that point
onward, as far as I can tell, the world moved on, and no one has touched
'llvm.noinline' in any meaningful way since.
It's time has now come. We have had better mechanisms for doing this for
a long time, all the frontends I'm aware of use them, and this is just
holding back progress. Given that it was never a documented feature of
the IR, I've provided no auto-upgrade support. If people know of real,
in-the-wild bitcode that relies on this, yell at me and I'll add it, but
I *seriously* doubt anyone cares.
llvm-svn: 152904
directly query the function information which this set was representing.
This simplifies the interface of the inline cost analysis, and makes the
always-inline pass significantly more efficient.
Previously, always-inline would first make a single set of every
function in the module *except* those marked with the always-inline
attribute. It would then query this set at every call site to see if the
function was a member of the set, and if so, refuse to inline it. This
is quite wasteful. Instead, simply check the function attribute directly
when looking at the callsite.
The normal inliner also had similar redundancy. It added every function
in the module with the noinline attribute to its set to ignore, even
though inside the cost analysis function we *already tested* the
noinline attribute and produced the same result.
The only tricky part of removing this is that we have to be able to
correctly remove only the functions inlined by the always-inline pass
when finalizing, which requires a bit of a hack. Still, much less of
a hack than the set of all non-always-inline functions was. While I was
touching this function, I switched a heavy-weight set to a vector with
sort+unique. The algorithm already had a two-phase insert and removal
pattern, we were just needlessly paying the uniquing cost on every
insert.
This probably speeds up some compiles by a small amount (-O0 compiles
with lots of always-inline, so potentially heavy libc++ users), but I've
not tried to measure it.
I believe there is no functional change here, but yell if you spot one.
None are intended.
Finally, the direction this is going in is to greatly simplify the
inline cost query interface so that we can replace its implementation
with a much more clever one. Along the way, all the APIs get simplified,
so it seems incrementally good.
llvm-svn: 152903
Only record IVUsers that are dominated by simplified loop
headers. Otherwise SCEVExpander will crash while looking for a
preheader.
I previously tried to work around this in LSR itself, but that was
insufficient. This way, LSR can continue to run if some uses are not
in simple loops, as long as we don't attempt to analyze those users.
Fixes <rdar://problem/11049788> Segmentation fault: 11 in LoopStrengthReduce
llvm-svn: 152892
which are small enough to themselves be inlined. Delaying in this manner
can be harmful if the function is inelligible for inlining in some (or
many) contexts as it pessimizes the code of the function itself in the
event that inlining does not eventually happen.
Previously the check was written to only do this delaying of inlining
for static functions in the hope that they could be entirely deleted and
in the knowledge that all callers of static functions will have the
opportunity to inline if it is in fact profitable. However, with C++ we
get two other important sources of functions where the definition is
always available for inlining: inline functions and templated functions.
This patch generalizes the inliner to allow linkonce-ODR (the linkage
such C++ routines receive) to also qualify for this delay-based
inlining.
Benchmarking across a range of large real-world applications shows
roughly 2% size increase across the board, but an average speedup of
about 0.5%. Some benhcmarks improved over 2%, and the 'clang' binary
itself (when bootstrapped with this feature) shows a 1% -O0 performance
improvement when run over all Sema, Lex, and Parse source code smashed
into a single file. A clean re-build of Clang+LLVM with a bootstrapped
Clang shows approximately 2% improvement, but that measurement is often
noisy.
llvm-svn: 152737
candidate set for subsequent inlining, try to simplify the arguments to
the inner call site now that inlining has been performed.
The goal here is to propagate and fold constants through deeply nested
call chains. Without doing this, we loose the inliner bonus that should
be applied because the arguments don't match the exact pattern the cost
estimator uses.
Reviewed on IRC by Benjamin Kramer.
llvm-svn: 152556
Renamed methods caseBegin, caseEnd and caseDefault with case_begin, case_end, and case_default.
Added some notes relative to case iterators.
llvm-svn: 152532
traversal, consider nodes for which the only successors are backedges
which the traversal is ignoring to be exit nodes. This fixes a problem
where the bottom-up traversal was failing to visit split blocks along
split loop backedges. This fixes rdar://10989035.
llvm-svn: 152421
http://lists.cs.uiuc.edu/pipermail/llvm-commits/Week-of-Mon-20120130/136146.html
Implemented CaseIterator and it solves almost all described issues: we don't need to mix operand/case/successor indexing anymore. Base iterator class is implemented as a template since it may be initialized either from "const SwitchInst*" or from "SwitchInst*".
ConstCaseIt is just a read-only iterator.
CaseIt is read-write iterator; it allows to change case successor and case value.
Usage of iterator allows totally remove resolveXXXX methods. All indexing convertions done automatically inside the iterator's getters.
Main way of iterator usage looks like this:
SwitchInst *SI = ... // intialize it somehow
for (SwitchInst::CaseIt i = SI->caseBegin(), e = SI->caseEnd(); i != e; ++i) {
BasicBlock *BB = i.getCaseSuccessor();
ConstantInt *V = i.getCaseValue();
// Do something.
}
If you want to convert case number to TerminatorInst successor index, just use getSuccessorIndex iterator's method.
If you want initialize iterator from TerminatorInst successor index, use CaseIt::fromSuccessorIndex(...) method.
There are also related changes in llvm-clients: klee and clang.
llvm-svn: 152297
This implicitly fixes a nasty bug in the GVN hashing (that thankfully
could only manifest as a performance bug): actually include the opcode
in the hash. The old code started the hash off with the opcode, but then
overwrote it with the type pointer.
Since this is likely to be pretty hot (GVN being already pretty
expensive) I've included a micro-optimization to just not bother with
the varargs hashing if they aren't present. I can't measure any change
in GVN performance due to this, even with a big test case like Duncan's
sqlite one. Everything I see is in the noise floor. That said, this
closes a loop hole for a potential scaling problem due to collisions if
the opcode were the differentiating aspect of the expression.
llvm-svn: 152025
equalities into phi node operands for which the equality is known to
hold in the incoming basic block. That's because replaceAllDominatedUsesWith
wasn't handling phi nodes correctly in general (that this didn't give wrong
results was just luck: the specific way GVN uses replaceAllDominatedUsesWith
precluded wrong changes to phi nodes).
llvm-svn: 152006
Some BBs can become dead after codegen preparation. If we delete them here, it
could help enable tail-call optimizations later on.
<rdar://problem/10256573>
llvm-svn: 152002
This change replaces getTypeStoreSize with getTypeAllocSize in AddressSanitizer
instrumentation for stack allocations.
One case where old behaviour produced undesired results is an optimization in
InstCombine pass (PromoteCastOfAllocation), which can replace alloca(T) with
alloca(S), where S has the same AllocSize, but a smaller StoreSize. Another
case is memcpy(long double => long double), where ASan will poison bytes 10-15
of a stack-allocated long double (StoreSize 10, AllocSize 16,
sizeof(long double) = 16).
See http://llvm.org/bugs/show_bug.cgi?id=12047 for more context.
llvm-svn: 151887
value numbers to be assigned when calculating any particular value number.
Enhance the logic that detects new value numbers to take this into account,
for a tiny compile time speedup. Fix a comment typo while there.
llvm-svn: 151522
%cmp (eg: A==B) we already replace %cmp with "true" under the true edge, and
with "false" under the false edge. This change enhances this to replace the
negated compare (A!=B) with "false" under the true edge and "true" under the
false edge. Reported to improve perlbench results by 1%.
llvm-svn: 151517
are optimization hints, but at -O0 we're not optimizing. This becomes a problem
when the alwaysinline attribute is abused.
rdar://10921594
llvm-svn: 151429
they'll be simple enough to simulate, and to reduce the chance we'll encounter
equal but different simple pointer constants.
This removes the symptoms from PR11352 but is not a full fix. A proper fix would
either require a guarantee that two constant objects we simulate are folded
when equal, or a different way of handling equal pointers (ie., trying a
constantexpr icmp on them to see whether we know they're equal or non-equal or
unsure).
llvm-svn: 151093
This transformation is not safe in some pathological cases (signed icmp of pointers should be an
extremely rare thing, but it's valid IR!). Add an explanatory comment.
Kudos to Duncan for pointing out this edge case (and not giving up explaining it until I finally got it).
llvm-svn: 151055
- Ignore pointer casts.
- Also expand GEPs that aren't constantexprs when they have one use or only constant indices.
- We now compile "&foo[i] - &foo[j]" into "i - j".
llvm-svn: 150961
metadata may still unwind, but only in ways that the ARC
optimizer doesn't need to consider. This permits more
aggressive optimization.
llvm-svn: 150829
useful to represent a variable that is const in the source but can't be constant
in the IR because of a non-trivial constructor. If globalopt evaluates the
constructor, and there was an invariant.start with no matching invariant.end
possible, it will mark the global constant afterwards.
llvm-svn: 150794
This folds a simple loop tail into a loop latch. It covers the common (in fortran) case of postincrement loops. It's a "free" way to expose this type of loop to downstream loop optimizations that bail out on non-canonical loops (getLoopLatch is a heavily used check).
llvm-svn: 150439
- Use unsigned literals when the desired result is unsigned. This mostly allows unsigned/signed mismatch warnings to be less noisy even if they aren't on by default.
- Remove misplaced llvm_unreachable.
- Add static to a declaration of a function on MSVC x86 only.
- Change some instances of calling a static function through a variable to simply calling that function while removing the unused variable.
llvm-svn: 150364
This allows BBVectorize to check the "unknown instruction" list in the
alias sets. This is important to prevent instruction fusing from reordering
function calls. Resolves PR11920.
llvm-svn: 150250
GlobalOpt runs early in the pipeline (before inlining) and complex class
hierarchies often introduce bitcasts or GEPs which weren't optimized away.
Teach it to ignore side-effect free instructions instead of depending on
other passes to remove them.
llvm-svn: 150174
* Most of the transforms come through intact by having each transformed load or
store copy the ordering and synchronization scope of the original.
* The transform that turns a global only accessed in main() into an alloca
(since main is non-recursive) with a store of the initial value uses an
unordered store, since it's guaranteed to be the first thing to happen in main.
(Threads may have started before main (!) but they can't have the address of a
function local before the point in the entry block we insert our code.)
* The heap-SRoA transforms are disabled in the face of atomic operations. This
can probably be improved; it seems odd to have atomic accesses to an alloca
that doesn't have its address taken.
AnalyzeGlobal keeps track of the strongest ordering found in any use of the
global. This is more information than we need right now, but it's cheap to
compute and likely to be useful.
llvm-svn: 149847
logic by half: isOnlyReachableViaThisEdge was trying to be clever and
handle the case of a branch to a basic block which is contained in a
loop. This costs a domtree lookup and is completely useless due to
GVN's position in the pass pipeline: all loops have preheaders at this
point, which means it is enough for isOnlyReachableViaThisEdge to check
that Dst has only one predecessor. (I checked this theoretical argument
by running over the entire nightly testsuite, and indeed it is so!).
llvm-svn: 149838
